Hi after digging through my garage I found this Mould. This gives you the opportunity to save a lot of weight over the standard tank (reduce your lap times :-) A great winter project. It allows you to make light weight replicas of the original steel tank for racing. Please note that it only makes the upper section of the tank.You could either make a fibreglass lower section to make a full tank or as I did made a much smaller aluminium tank which fits inside the dummy tank. The Green tank is just for illustration and an example of the tank I made from this mould.
If you haven't done fibre glassing before then this is a great site for materials and information. Thanks for looking and if you have any questions please contact me. I also have the tank that I made for sale so check out my other items for sale. This item is in the category "Vehicle Parts & Accessories\Motorcycle Parts\Other Motorcycle Parts".The seller is "timmy123w" and is located in this country: GB. This item can be shipped to United Kingdom, Antigua and Barbuda, Austria, Belgium, Bulgaria, Croatia, Republic of, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Australia, Canada, Japan, New Zealand, China, Hong Kong, Norway, Indonesia, Malaysia, Mexico, Singapore, Korea, South, Switzerland, Taiwan, Bangladesh, Belize, Bermuda, Barbados, Cayman Islands, Dominica, Guernsey, Gibraltar, Guadeloupe, Grenada, French Guiana, Iceland, Jersey, Jordan, Cambodia, Saint Kitts-Nevis, Saint Lucia, Liechtenstein, Sri Lanka, Macau, Monaco, Montserrat, Martinique, Oman, Pakistan, Reunion, Turks and Caicos Islands, Aruba, Saudi Arabia, South Africa, United Arab Emirates, Bahamas, Colombia, Kuwait, Philippines, Qatar, Uruguay, Russian Federation.